I am looking for software help on a CAN interface that is on the TI CP3UB26 microcontroller as well as on the NatSemi/TI CR16 family. Does TI have any software drivers for this CAN peripheral? Thank ...

our soc application need to open "/dev/dma_heap/carveout_edgeai_shared-memories", but in the development board, there is just 'linux,cma' and 'system' node in /dev ...

We have two TI chips: LMR38020FDDAR and TPS62826ADMQ connected together on 2 of our designs in the following way: So, the 5V coming from the LMR38020FDDAR is connected into the Vin of the TPS62826ADMQ ...

Note - all references to issuing commands and displaying data refer to the use of BQStudio and an EV2400. Also just to provide context, I have a BQ27520EVM connected to a BQ41Z50EVM, and my ultimate ...

Page 4 of SLUUD32 says "Find the latest firmware in the appropriate BQ41Z50 folder on www.ti.com". Where can the actual *.bq.fs file be found (need the file, or a better link than just www.ti.com).

The open-loop gain in the simulation result (59.9V/mV) is smaller than the minimum value (70V/mV) in the datasheet. Does this mean that the gain in the SPICE model is smaller than the gain in the ...

I have some questions about the manual. 1.Which register does this reset refer to?FRAME_CNT_THRESHOLD(46H) or FRAME_CNTx(45H)? 2.Is the error counter mentioned in the ...

We are using TCAN1145-Q1 to judge it is wake up frame from the network or not by CANINT register bit. While we found when there are other nodes receiving WUF, this TCAN1145 node cannot assert register ...

Reg63 ”DAC Channel Volume Control's Soft-Step control”...Soft-Stepping is 1 step per 1 or 2 DAC Word Clock I would like to check whether there is any pop noise when switching from maximum volume to ...

I met the similar problem when using ads1274EVM-PDK, And of course, the USB device was enumenated under NI-VISA USB Devices: My PC is Windows 10 64 bit. In C:\Program Files (x86)\ADCPro\drivers ...

I'm using the ADC128S102 EVM and I did some measurements I want to save to a log file. I the GUI there is such option but I cant find the location the Log file is generated to. Please help here.